Remaches

Becherblindniet AlE-4,8

Remache estanco Al/E 4,8

Remaches

Cuerpo de remache de aluminio (Al) Tornillo de acero inoxidable (E)
Mehrbereichsblindniet-ECORIV_Pos2

Al/E 4,8 remache ciego

Remaches

Cuerpo de remache de aluminio (Al) Tornillo de acero inoxidable (E)
Blindniet-ECORIV-K14

Al/E C14

Remaches

Cuerpo de remache de aluminio (Al) Tornillo de acero inoxidable (E)
Presslaschenblindniet-ECORIV_Pos2

Remache Bulbtite EJOT®

Remaches

Cuerpo de remache de aluminio (Al) Tornillo de aluminio (Al)

 

 

 

Rivets

The blind rivet is installed by pulling back the mandrel with a special tool, whereupon the mandrel head penetrates into the rivet and expands the protruding material to a closing head.

 

Installation process blind rivets:

  1. The mandrel of the blind rivet is set into the installation tool and then inserted into the rivet hole. The rivet mandrel is gripped and pulled with the clamping jaws by triggering the installation tool stroke.
  2. The rivet mandrel head thus deforms the shaft end of the rivet body. The process is completed when the mandrel head reaches the height of the component surface.
  3. This position is connected with a strong force increase, at which the rivet mandrel tears off at its predetermined breaking point. The torn mandrel is removed, the residual rivet mandrel remains in the rivet.